Toner Cartridges Maintenance Tips
Toner cartridge is
daily common office supply. The usual maintenance is important to keep the
printer having printed effects for working. Now let me share some techniques
for you and I think it can apply into your daily toner cartridge’s maintenance.
1.
When
the toner cartridge in use after a period of time, there are more or less
pollution to the toner cartridge, then we will find that the output of the text
is not exactly clear, the bottom ash is aggravating and glyph longer, then it
needs us to clean the toner cartridge. Before cleaning the toner cartridge,
firstly you should take down each component carefully, use absorbent cotton or
senior camera lens paper wipe the surface of OPC. Be carefully not to be too
hard when you operating, other the surface will be easily scratched. Then we
should also use the absorbent cotton or senior camera lens paper dipping with
the OPC special cleaner to wipe its surface. We should wipe gently along a
direction of spiral circle type, next you can clean the cleanser immediately
after polishing. Finally, using talcum powder, to a layer of talcum powder is
lightly coated on the surface of toner cartridge and then the whole cleaning
process is finished.
2.
Clean
off the waste toner
For the user who adding powder,
after a long period of time using, waste powder will have accumulated in waste
collection storehouse, such as tn660 toner. If
not timely clear off this toner, it will affect the printing effect, even lead
to powder leakage if the situation is serious. If appearing the toner leakage,
it will directly lead to output manuscript appeared on the black spots,
irregular black block. If not clear up the waste power and let it continue to
use accumulate, the waster powder will pile up and the friction pressure of the
OPC is more and more tight, which will eventually tear off the photosensitive
drum coating on the drum surface, and damage the whole drum unit. The method of
cleaning up is very simple, as long as open the collection silo, use cotton
swab or paper towel to directly remove waste power and clean.
3.
Don’t
overload the toner cartridge
Any one thing has its working
load, however, the OPC is an organic silicon photoconductor and there is also
existence the problem of “work fatigue”. If it’s used continuously for long
time, the light effect is affecting the print output, and if the situation is
serious it will even “announce the strike”. Therefore, the users should
remember to make toner have a rest properly. Generally, if is continuous to do
a lot of output printing work, I suggest you make it rest in 8 to 12 hours. If
you have to print day and night to finish your work, you should lay it aside
for some time after reusing. So I recommend that we had better buy more than
two toner cartridges to interchange use, so it
can avoid the toner fatigue and does not affect the work.